Tweet

Posted on 02 May 2019

650V Rapid Diode for Industrial Applications

 

 

 

 

 

 

 

With the introduction of Rapid Diodes, Infineon Technologies enters the hyperfast fast high voltage silicon diode market. Based on ultrathin wafer technology, two families are released to cover different application requirements. Rapid 1 is used in low switching applications (up to 40 kHz) whilst the Rapid 2 is used in fast switching applications (up to 100 kHz).

This application note was designed to show how the Rapid diode will improve the existing system solution for its targeted applications in terms of efficiency and soft reverse recovery behavior. The Rapid diode portfolio can also be found at the end of this application note.

View the full Application Note

 

VN:F [1.9.17_1161]
Rating: 4.5/6 (4 votes cast)
650V Rapid Diode for Industrial Applications, 4.5 out of 6 based on 4 ratings

This post was written by:

- who has written 155 posts on PowerGuru - Power Electronics Information Portal.


Contact the author

2 Responses

  1. avatar MANOJ says:

    please send me the details of rapid diode.

    VA:F [1.9.17_1161]
    Rating: 0.0/5 (0 votes cast)
    • avatar PowerDahl says:

      Hello MANOJ,

      Did you read the full application note that is linked to at the bottom of the post? Much information about the Rapid Diode can be found there. If you need more specific information about the diodes, you can visit Infineon's support page: http://www.infineon.com/support/

      Regards

      VN:F [1.9.17_1161]
      Rating: 0.0/5 (0 votes cast)

Leave a Response

You must be logged in to post a comment.